Product news

It is possible to order a custom-built ST-01 Speed Gate:

• with Swing Panels made of plexiglass or polycarbonate,
• with front panel used for installation of barcode reader,
• with the stand for the installation of a face recognition module,
• other variants for needs of the customer.

Improved packaging: it is now possible to stack boxes in 7 rows.

Improved packaging: it is now possible to stack boxes in 5 rows.

The design of ST-01 Speed Gates has been improved:

a) The indication block is built directly into the section cover.

b) The indication control module has been added to the upper side of the housing.

It is now easier to install readers inside of the section and to switch the type of indication of the front end indication module (select "Arrow" or "Cross").

Upon the requests of users, in addition to the main modes of operation, a special "Automatic opening of the passage in the selected direction" mode has been introduced.

In this mode, the Swing Panels open automatically when entering the turnstile in one direction and immediately close after the passage is finished; in the other direction, the turnstile works according to the usual algorithm. The mode is activated by switches located on the Control Board.

If the product was purchased earlier, and the customer needs this new feature – it is possible to update the firmware of the controller, please contact our technical support.